Uncategorized
Bowden Buddys
Upgrades I added some new parts to the optional folder on github There is one bracket for the bowden sleeve to fix on the frame and two parts for the X-Carrier Video here
Controllers
Controller Board Spacers
Controller Board Spacers If you have a bottom enclosure you might like the standoffs/spacers I added to the optional folder on github. There is one for the MKS Gen L and one for the Duet Wifi
Hardware
New Worm Gear Supplier
As the current wormgear supplier have been of very variable quality I have a new supplier in place which looks to be better and CHEAPER! BOM is updated Link to new supplier
Controllers
Review – ST820 Stepper Drivers
ST 820 Review – Short I did not find a need for the ST820 drivers on a 8 bit board. Reason for this is that we can not utilize more than 1/32 micro-stepping due to restrictions by the ATmega2560 mictochip Read more…
Printed Parts
Tolerances – Some parts are to tight!?
Some parts are to tight! Thanks for the feedback in the builders club. It is important feedback so I can adjust and improve the design So there is the XYZ fork and I also recognized the belt locks myself being Read more…
Printed Parts
X-Carrier Assembly Info
Adapt the holes On earlier versions of the X-Carrier the vertical holes for the wheels are to tight. Use a 5.5mm drill to get these up to standards as you don’t want the wheels to low on the carrier. This Read more…
3d modeling
Good article for 3d modeling hardware
Here is a good article about pc hardware for 3d modeling and rendering Best Computer for 3D Modeling and Rendering
