Controller Cables

Published by Roy Berntsen on

How Can We Help?

< Back
You are here:

Recommended Controller Cables

I recommend drag chain cables like the picture below. These are made to move and is essential for the bowden path and recommended for all round

Cat5, Cat6 etc. Ethernet Patch 24AWG cables can be used for the low current components as well if you are looking for a budget version or not been able to source drag chain cables.

NB! DO NOT use this for the hotend heater!

For 24V system AWG 24 or 0,20 mm^2 is suitable for most components. Look at the table linked below to configure for your setup

If you have 12V system there are more current running through so check the table and use Ohms law to calculate your needs and look in the table

Wire Gauge Table

See her for max amp draw and size

Table of Contents