Standard NEMA 17 – 1.7 Amp motors is what fits with stock setup as in this link. You need 4x motors for stock setup You want 1M wires if mounting the controller in the bottom part of the printer The Dupont connector on the linked motors acts like a common Read more…
MKS Gen l Connection Points MKS Gen l Pinout Scheme MKS Gen l FAN Out For always on Heatsink/HotEnd Fan use connection point with green ring in the scheme attached For temperature controlled Heatsink/HotEnd Fan use D7/secondary extruder heater pinout in yellow below
Jumper Tables: TMC2208 A4988 – DRV8825 Vref settings All settings are based on 24V input For detailed instructions read here: Link These numbers are approximations for 1.7Amp stepper motors. Use the link above to calculate your own Vref These settings are for standalone drivers – uart and SPI N/A Causion: Read more…