Parts – Print Settings

Published by Roy Berntsen on

How Can We Help?

< Back
You are here:
Print

Slicer Recommendations

Material: Filamentum CPE or some PETG is recommended

  • Walls: 2.0 mm Shell
  • Bottom/Top: 2.0 mm shell at 0.2-0.25 layer height
  • For the 30/1 wormgear the magical layer numbers are 0.125 and 0.250
  • Infill: 20% – 100%

You do need a good calibrated extruder as parts are tight so check your flow
All parts are modeled with tolerance to fit but some holes might need post processing

Support is needed on some parts – See part Suffix

Table of Contents
Categories: