Controller Cables

Recommended Controller Cables I recommend drag chain cables like the picture below. These are made to move and is essential for the bowden path and recommended for all round For 24V system AWG 24 or 0,20 mm^2 is suitable for most components. Look at the table linked below to configure Read more…

The Bowden Path

The Bowden Tube The path for guiding the filament from the extruder to the hotend is a standard PTFE/Teflon tube at 2mm ID 4mm OD for 1.75 mm filament I recommend approximately 80 cm of ptfe for this path The Rod To hold up the bowden tube and cablingĀ  while Read more…

Bed Heater

Silicone Heater I would go with 220V every day and I really think it is a less fire hazard that the 24V option as you would need so much more current to reach a decent power. I have a 1000W heater and it only takes about 5 amp If same Read more…

Cable Managment

Recommended Cables – Connectors & Tools Video describing controller cables here Tools For ease of wiring and adding connectors I recommend the PA-20. You can read more about them here You can buy the PA-20 here Power Supply Wiring From the Switch to the PSU From the VAC we have Read more…

BL-Touch

Bed Leveling Sensor BL-Touch is an auto leveling sensor for FDM 3D Printers that can precisely measure the tilt of Bed surface. It could work with any kinds of bed materials, such as glass, wood, metal or what your flavor is Connect the probe The 3 lead goes to servo Read more…