Printed Part Materials

 I recommend using PETG or optimally CPE from Filamentum for all parts PLA will work on all parts for a long time but it is brittle and tend to crack sooner or later. PLA also has low TG and will soften at 50C+ so hot sone parts might degrade That Read more…

V-King Build Volume

Build Volume I advice not going over 400*400 with stock frame and belt sizes – You can configure your own here: V-King BuildVolume Calculator Stock Frame Stock build volume with all 500mm extrusions and 2020 corner cubes is approximately 340*380*330 The X travel depends on how you organize the belts Read more…

Corner Cubes

The 3 way corner cubes is good to have but not necessary If you use the corner cubes you should use them together with countersink M5x8 screws or they will not be centered to the V-Slots Always use the 2028 aluminum corner brackets with or without the corner cubes