Start & End Code

These are basic start and end codes for the V-King Start Code – Without ABL G28 ; Home XYZG92 E0 ; Zero ExtruderG1 F6000 X0 Y350 Z0.3 E ; Move to corner Z0.3 and purge 5mm of filamentG1 F3600 X0 Y200 E25 ; PrimeG1 X0 Y200 Z5 ; Raise NozzleG1 Read more…

Controller – MKS Gen L

MKS Gen l Connection Points MKS Gen l Pinout Scheme MKS Gen l FAN Out For always on Heatsink/HotEnd Fan use connection point with green ring in the scheme attached For temperature controlled Heatsink/HotEnd Fan use D7/secondary extruder heater pinout in yellow below  

Stepper-Driver Settings

Jumper Tables: TMC2208 A4988 – DRV8825 Vref settings All settings are based on 24V input For detailed instructions read here: Link These numbers are approximations for 1.7Amp stepper motors. Use the link above to calculate your own Vref These settings are for standalone drivers – uart and SPI N/A Causion: Read more…