Viking 3D Printers

  • Home
  • Viking 3D Wiki
  • News & Rants
  • Gallery
  • Youtube videos
  • Newsletter
  • Login

Printed Parts

3D Printing

Advanced 3D Printing with Cura

By Roy Berntsen, 3 yearsJanuary 11, 2020 ago
Assembly

Updated Corner Idler Brackets

I did some minor changes so it can be printed without suppport – Github is updated

By Roy Berntsen, 4 yearsMay 18, 2019 ago
Assembly

Revised Layer Fan

I redesigned the fan shroud so it does fit better around the heat block without coming in conflict with the heater cartridge It is updated in the github stock stl library

By Roy Berntsen, 4 yearsDecember 21, 2018 ago
Printed Parts

Tolerances – Some parts are to tight!?

Some parts are to tight! Thanks for the feedback in the builders club. It is important feedback so I can adjust and improve the design So there is the XYZ fork and I also recognized the belt locks myself being to tight. This has now been fixed and uploaded to Read more…

By Roy Berntsen, 4 years ago
Printed Parts

X-Carrier Assembly Info

Adapt the holes On earlier versions of the X-Carrier the vertical holes for the wheels are to tight. Use a 5.5mm drill to get these up to standards as you don’t want the wheels to low on the carrier. This has lately been fixed but it might be an issue Read more…

By Roy Berntsen, 4 years ago
  • Home
  • Viking 3D Wiki
  • News & Rants
  • Gallery
  • Youtube videos
  • Newsletter
  • Login
Hestia | Developed by ThemeIsle
This website uses cookies to improve your experience. We'll assume you accept this policy as long as you are using this websiteAcceptView Policy