Viking 3D Printers

  • Home
  • Viking 3D Wiki
  • News & Rants
  • Gallery
  • Youtube videos
  • Newsletter
  • Login

Roy Berntsen

Uncategorized

Z Carrier Source File

I added Z-Carrier and XYZ Carrier Fork to source files Happy building! Happy building

By Roy Berntsen, 4 yearsJanuary 4, 2019 ago
Assembly

Revised Layer Fan

I redesigned the fan shroud so it does fit better around the heat block without coming in conflict with the heater cartridge It is updated in the github stock stl library

By Roy Berntsen, 4 yearsDecember 21, 2018 ago
Uncategorized

V-King 3d Model

I added a link to the V-King top assembly so you can view it in A360 This can be helpful when putting everything together by zooming, rotating and viewing the parts from different angles Ask in the builders chat for passwd to accesslink

By Roy Berntsen, 4 yearsDecember 17, 2018 ago
Uncategorized

Bowden Buddys

Upgrades I added some new parts to the optional folder on github There is one bracket for the bowden sleeve to fix on the frame and two parts for the X-Carrier Video here

By Roy Berntsen, 4 yearsNovember 17, 2018 ago
Cable Management

Cable Looms

By Roy Berntsen, 4 yearsNovember 12, 2018 ago
Controllers

Controller Board Spacers

Controller Board Spacers If you have a bottom enclosure you might like the standoffs/spacers I added to the optional folder on github. There is one for the MKS Gen L and one for the Duet Wifi

By Roy Berntsen, 4 yearsNovember 11, 2018 ago
Hardware

New Worm Gear Supplier

As the current wormgear supplier have been of very variable quality I have a new supplier in place which looks to be better and CHEAPER! BOM is updated Link to new supplier

By Roy Berntsen, 4 yearsNovember 8, 2018 ago
Controllers

Review – ST820 Stepper Drivers

ST 820 Review – Short I did not find a need for the ST820 drivers on a 8 bit board. Reason for this is that we can not utilize more than 1/32 micro-stepping due to restrictions by the ATmega2560 mictochip The drivers are acting pretty much like the DRV8825 drivers Read more…

By Roy Berntsen, 4 yearsNovember 1, 2018 ago
Printed Parts

Tolerances – Some parts are to tight!?

Some parts are to tight! Thanks for the feedback in the builders club. It is important feedback so I can adjust and improve the design So there is the XYZ fork and I also recognized the belt locks myself being to tight. This has now been fixed and uploaded to Read more…

By Roy Berntsen, 4 years ago
Electronics

Fans – Testing Blowers

By Roy Berntsen, 4 yearsOctober 25, 2018 ago

Posts navigation

Previous 1 2 3 4 Next
  • Home
  • Viking 3D Wiki
  • News & Rants
  • Gallery
  • Youtube videos
  • Newsletter
  • Login
Hestia | Developed by ThemeIsle
This website uses cookies to improve your experience. We'll assume you accept this policy as long as you are using this websiteAcceptView Policy